Ready Stack - Chardonnay SAMPLE

I did not notice any instructions on installing the ready stack. There were only installation instructions for single stone, stone veneer, even when clicking on the link under ready stack. Are the instructions the same? Video instructions would also be helpful.

Thank you for your question and interest in our stone veneer. Our ready stack profile is a mini panel stone product and is installed in sections at a time https://mountainviewstone.net/collections/ready-stack. Each panel measures 4” high but will vary in length (5.5”, 8.25”, 11”, 16.5”) and thickness (1.5”-2.5”). Each ready stack panel has multiple stones on each panel face. To achieve the desired finish as shown in our images it is up to the installer to arrange the panels in the correct pattern and install each panel one at a time. Installation is the exact same for ready stack as it is for all our stone veneer products. We do not have an installation video available at this time, however, our installation instructions can be downloaded at https://mountainviewstone.net/pages/post-purchase-support. For the surface prep, which is the most important step, you will need to install a moisture barrier and then install wire lath over that. Make sure the nails or screws for wire lath hit studs to ensure a good foundation. Your scratch coat goes over the wire lath and then the stone veneer. We recommend our stone veneer and brick veneer be installed with Type S mortar. Mortar is recommended for installation opposed to an adhesive as mortar is cheaper than adhesive, and when installing with an adhesive you must hold the stone in place until the adhesive sets which really slows down installation time, whereas mortar instantly holds. Please let us know if you have any more questions!